SAE Battery Tender Chargers Prevent Low Battery Failure 12 Volt Discharge Alarm

Regular price $15.95

Goes in series with your Battery Tender cable and will monitor the battery charge state. Will make sure your charger is plugged in, working and prevent the battery from going below the 50% charge level. Works with any battery charger. Can also be used without a charger when you are just storing the car, motorcycle, RV, ATV, snowmobile, boat etc. 

SAE cable low voltage monitor alarm. 

Prevents dead batteries when in storage or when in use.

 

The Alarm will sound if your battery becomes discharged to the level at which it must be charged.

Avoid dead battery due prolonged use, due to power failure, charger failure. Lets you know when battery must be charged. #BA10

Works with all kinds of 12 volt batteries. Plugs into your active SAE cable and monitors your battery voltage for a low voltage condition.

For all kinds of storage batteries- Lead Acid, Gel Cell, AGM.

Ideal for vehicles that are in storage or with any 12 volt battery being stored for a prolonged period.

Use this with your battery charger to alert you to a power failure. This will tell you when your battery must be charged.

 

 

This device goes across your battery with the 12" SAE cable in series with your charger or stand alone. If your battery gets discharged below 12 volts standard( can be factory set between 10-14V upon request) the alarm will sound and a red LED will glow. This allows you to know when you must begin recharging your battery before the discharge becomes excessive and permanent loss of battery life occurs. Alligator clips allow you to attach this to any 12 volt battery.

 

 

Ideal for Motorcycles, Cars in storage, Snowmobiles, ATV, Boat batteries, Generator starting batteries, RV battery banks, Sump pumps, well pumps, sewage discharge pumps and bilge pumps.

This listing is for one (1) battery monitor with alarm with rubber cover and caped SAE cable. Polarity is reversible if required. When the battery voltage drops below 12 volts the alarm and LED will be active. The alarm is a 80 db tonal alarm at 3000 hz. Operate down to 8 volts and up to 15 volts. Do not exceed 16 volts.

Add a mount ( paste the item number into the eBay search box):

Surface mount 121173709659 .

Enclosed surface mount 301807948007 .

Handlebar mount 122799479105