Prevent Dead Battery SLA AGM Alarm w/ Mute Switch LED 12V Coulomb Discharge Monitor #CBA7A-M

Low Battery Detector, prolongs battery life and prevents dead batteries- Panel mount. #CBA7A-M

Your battery can be ruined or battery life diminished if it is allowed to discharge below the 50% charge state.

This is a detector alarm with mute button switch. The alarm will sound if your battery becomes discharged to the level at which it must be charged. A low battery capacity state. The loud tonal alarm will sound and a red internal LED will illuminate to indicate discharge state. A front mounted push on, push off mute button allows you to turn off the tonal portion of the alarm. Ths internal red LED will continue to glow while the alarm condition exists. The alarm condition is cleared when the battery is recharged.

Avoid dead battery due normal use, or due to long term storage without use, charger failure. Lets you know when battery must be charged. 

Works with all kinds of 12 volt batteries.

For all kinds of storage batteries- Lead Acid (SLA), Gel Cell, AGM and Lithium Ion. This alarm is avaialble for SLA /Gel, AGM or Lithium ion batteries. The voltage detector level varies.

Ideal for vehicles that are in storage or with any 12 volt battery being stored for a prolonged period.

Use this with your battery charger to alert you to a power failure. This will tell you when your battery or battery bank must be charged.

This device is connected to your battery. For SLA or AGM batteries or deep cycle if your battery gets discharged below below the 50 % (12.0V) point, the alarm will sound and a red LED will glow. To turn the alarm sound off press the mute button.This allows you to know when you must begin recharging your battery before the discharge becomes excessive and permanent loss of battery life occurs. 

Ideal for Motorcycles, Cars in storage, Snowmobiles, ATV, Boat batteries, Generator starting batteries, RV battery banks, Sump pumps, well pumps, sewage discharge pumps and bilge pumps.

This listing is for one (1) battery monitor with alarm and mute button. Comes pre-wired, ready to install. When the battery voltage drops below 12.0 volts the tonal alarm and LED will be active. The alarm is a 80 db piezoelectric alarm at 3000 hz. Operate down to 8 volts and up to 15 volts. Do not exceed 16 volts.

Mounting hole size 1-1/8" in diameter. 

CBA7A-M fits in panels up to 1" thick.