For outdoor use. Can be exposed to the rain and water spray. Waterproof IP65. An internal conical barrier allows sound and light out but prevents water intrusion. Three seal waterproof construction.
Attention getting warning indicator alarm with flashing extra bright four LEDs and 110db sound. When activated, one second on and off beep tone. Put this alarm in parallel with any 12 volt warning light to be notified when there is a problem.
Used for custom dashboard or operating panels. Will operate on AC or DC 12 volts. #CAL1WP
This listing has two options. One with just the panel mounted alarm and one with the alarm and rubber terminal boot, The terminal boot covers the back of the alarm and allows you to make your connections inside the boot to protect them from weather.
For bilge alarms, Engine over heating, sump pump activation and low oil pressure.
Use with Boats, RV, Motorcycle, trucks, cars ATVs, snowmobiles, marine
Notifier type
Matches our standard line of 12 volt accessory or lighter sockets, USB charger sockets, switches and voltmeter. Used for custom dashboard or operating panels. With operate on DC 12 volts.
This is a listing for one panel dashboard mounted socket alarm and warning indicator. Can be purchased with or without the terminal boot. When 12 volts is applied the piercing tonal alarm and bright quad LED flash on and off in a one second interval cycle. The connections are two male 0.250 nylon insulated disconnect spade terminals on a wire 16 gauge pigtail. The leads are non-polarized and will work with 12 volts AC or DC.
-Waterproof IP65
-Working Voltage: DC/AC 12 Volts +/- 20%
-Non-polarized connections.
-Anti-shock capability.
-Mounting Hole: 1-1/8" Panels of up to 1-1/2" thick with backing nut.
-Continuous Working Life 30000h
-Sound volume: 100db@ 10cm
-Sound type: intermittent one second on/off
-LED Brightness: 6000 mcd
-Minimum Working Current: 20mA
-Connections male 0.250 fully insulated spade terminals.
You might also like
