- Fast installation with wires and quick connections.
This listing is for one kit consisting of a voltmeter, 3.1 Amp dual USB charger, 12 volt accessory socket, illuminated SPST switch and a quad mounting plate, interconnecting jumper wires, and mounting screws. #QCN/swb3/CR/CVMB/CU/Fplt/4sq
Ships from the USA.
Daisy chain jumper wires when combined with the switch allow you to connect up the elements and make one connection to your battery.
The switch turns on and off the assembly. Draws no power when the switch is off.
12 Volt Power Socket.
UV stabilized nylon housing with rubber splash proof tight fitting front cap
2 pole nickel plated terminal connectors. 0.250 male spade type.
Works with all 12 volt accessory plugs.
Rated for 15 amps at 12 volts peak 20 amps. draws 5 ma.
Dual USB Charger
Comes with front cap and heavy duty construction.
UV Nylon Body.
Suitable for interior or exterior use.
Suitable for charging GPS, iPhone, iPod, Mobile Phones and other digital devices
2 port USB Socket
Power Input: DC 12V-24V
USB Socket I Power Output:DC 5V 1A
USB Socket II Power Output: DC 5V 2.1A
Output: 5V 3.1A DC(Total)
Waterproof USB Cap
Display: segment LED digital tube, lamp display is blue, red available upon request.
Monitors the state of your battery between full charged and discharged
Can indicate a poor or bad charging system. Tells whether your battery is holding a charge or not
The meter has easy to read LED segments and connect to your 12 volt system.
The meter draws nominally 10 ma. and the range is to 35 vdc.
Splash proof front and back. Blue (Red available upon request) Illuminated Waterproof Rocker Switch –SPST. Nylon threaded switch housing mount in a 1-1/8" hole. Can be mounted in panels or dashboards up to 1-1/4" thick with the retaining nut and in panels of unlimited thickness with the mounting plate. Rated for 16 amps at 12 volts. IP rating 63. Has male Ľ" crimp style disconnect terminals. Illumination is low intensity for easier night vision. Three wire connection:
The quad plate
The four devices mount in individual 1-1/8" holes, in panels of unlimited thickness, an optional nylon retaining nut can be used to holds the devices in place on panels of less than 1-1/2" thick. See Drilling template for mounting dimensions.
The mounting plate fits over the front of the devices to hold them against panel or dashboard. Held in place by four black screws included.