Triple 3.1 A USB Charger + Blue Voltmeter +12 Volt Socket Panel Outlet Fused Harness

Regular price $14.95

Now with interconnecting daisy chain jumper wires, fused 36" wire cable and rubber mounting washers.

This listing is for a blue volltmeter ( also avaialble in red), 3.1 Amp dual USB charger, 12 volt accessory socket, triple mounting plate and mounting screws. #QCN/CR/CVB/CYBD/Qplt/3sw/4sq

Ships from the USA.

Marine Grade 12 Volt Power Socket
For Motorbike Car/Boat/ATV/UTV/Camper/Caravans/ Travel Trailer etc
Specifically designed for marine and motorcycle applications
UV stabilized nylon housing with rubber splash proof tight fitting front cap
2 pole nickel plated brass terminal connectors. 0.250 male spade type.
Twist-and-Lock locking socket, allows a suitable power plug (not included) to lock into place. Works wth all 12 volt accessory plugs.
Rated for 15 amps at 12 volts peak 20 amps. draws no power when not in uses.

Dual USB Charger
Comes with front cap and heavy duty construction.
Suitable for interior or exterior use.
Suitable for charging GPS, IPhone, IPod, Mobile Phones and other digital devices
Specification:
2 port USB Socket
Waterproof Design
Power Input: DC 12V-24V
USB Socket I Power Output:DC 5V 1A
USB Socket II Power Output: DC 5V 2.1A
Output: 5V 3.1A DC total.
Waterproof USB Cap

DC Voltmeter
Display: segment LED digital tube, lamp display is blue.
Monitors the state of your battery between full charged and discharged
Can indicate a poor or bad charging system. Tells whether your battery is holding a charge or not
The meter has easy to read LED segments and connect to your 12 volt system.

The meter draws nominally 10 ma. and the range is 0-35 vdc

Fused cable 36" cable with terminations and a waterproof fuse holder and 15 amp fuse.

The triple plate and mounting washers.

Rubber mounting washer go between the components and the mounting surface as shown in the assembly drawing to make a vibration proof and water tight seal.

The three devices mount in individual 1-1/8" holes, in panels of unlimited thickness, an optional nylon retaining nut can be used to holds the devices in place on panels of less than 1-1/2" thick. See Drilling template for mounting dimensions.

The mounting plate may differ from what is shown and allows for the assembly to be mounted in 1-1/8" holes with or without the backing nut. The plate fits over the front of the devices to hold the elements against panel or dashboard. Held in place by four black screws included. If the backing nut is used to secure the elements to the panel/ dash then the plate is merely decorative.