Twin 4.2 amp USB chargers and interconnecting wire. Combine to produce a total of 8.4 amps. Each charger is true 4.2 amp dual USB charging socket with twin mounting plate and screws, mounting washers, and heavy weather sealing caps. Also included in a daisy chain jumper wire to interconnect the two chargers.
Mounts in panels of unlimited thickness.
Ships from the USA.
Charges an array of iPods, iPhones and other USB accessories at the same time, at full power.
This listing is for one twin USB dual charger socket with weatherproof cap. Attaches to your 12 volt source and allows you to charge USB accessories. #Ycn/2cw/tplt/4sq/2sw/2mw
What is a true 4.2 Amps?
Many charger are nominally rated or not rated at all. Other charging socket output 1, 2.1, 3.1 Amps, but these rating may only represent the maximum peak output rating and can not sustain that output for a prolonged period. Our chargers, including this one, at 4.2 Amps, are true rated which means they can maintain the rated output current for an indefinite period. This allows you to charge your USB accessories at maximum power. This charger's output is the highest in the industry. Each of the dual port can output a true 2.1 amps. Should your device require more than 2.1 amps the power is distributed as need to the individual ports up to 4.2 amps.
The charger's housing and charger are one piece, designed for outside use. The heavy weatherproof cap fits into and over the front of the charger to keep moisture out when not in use. This cap, unlike other caps, covers all of the individual USB port openings. The rubber washer provide a waterproof seal when panel mounting. The socket has 0.250 male spade type terminals for easy wire connections. The daisy chain jumper wire connects both chargers together and allow for one connection to your 12 volt source.
No LED, means lower power consumption.
Each charger is rated for 4.2 amps at 5 V and can accept two USB devices. Unlike
less expensive charger / adapters, this charger use built in integrated semiconductor technology to produce
a constant 5 Volts DC This constant
voltage source is important for operating and charging the batteries of your
accessories, from a 12 volt source.
With the mounting the charger can be mounted in a panel of any thickness, see illustration. The mounting plate goes in front of the chargers and is used to compress the chargers against a panel to hold them in place in that panel. This requires a 1-1/8" hole to be drilled for each charger.