This listing is for a Voltmeter, 3.1 Amp dual USB charger, 12 volt heavy duty lighter/ accessory socket with a lighter plug and plug boot, illuminated SPST switch, a quad mounting plate, interconnecting jumper wires and mounting screws. #qcn/swb3/cvmb/cybd/ctd/splg/pba/fmnt/4sq
Ships from the USA.
Daisy chain jumper wires when combined with the switch wires allow you to wire all the elements and make one connection to your battery. Comes with instructions.
Heavy duty 12 Volt Combination Power Socket and Cigarette Lighter Socket and Lighter Plug with Boot.
UV stabilized nylon housing with rubber splash proof tight fitting front cap
2 terminal nickel plated brass terminal connectors. 0.250 male spade type.
Works with all 12 volt accessory plugs. Also works with the pop-out lighter plug included. the lighter plug has a boot that seals the opening.
Rated for 20 amps at 12 volts.
Dual USB Charger
Comes with front cap and heavy duty construction.
UV Nylon Body.
Suitable for interior or exterior use.
Suitable for charging GPS, iPhone, iPod, Mobile Phones and other digital devices
2 port USB Socket
Power Input: DC 12V-24V
USB Socket I Power Output:DC 5V 1A
USB Socket II Power Output: DC 5V 2.1A
Output: 5V 3.1A DC(Total
Waterproof USB Cap
Display: segment LED digital tube, lamp display is blue, red available upon request.
Monitors the state of your battery between full charged and discharged
Can indicate a poor or bad charging system. Tells whether your battery is holding a charge or not
The meter has easy to read LED segments and connect to your 12 volt system.
The meter draws nominally 10 ma. and the range is 0-35 vdc.
Splash proof front and back. Blue (Red available upon request) Illuminated Waterproof Rocker Switch –SPST. Nylon threaded switch housing mount in a 1-1/8" hole. Rated for 15 amps ( 20 amp peak) at 12 volts. IP rating 63. Has male Ľ" crimp style disconnect terminals. Illumination is low intensity for easier night vision. T
The quad plate
The four devices mount in individual 1-1/8" holes, in panels of unlimited thickness, an optional nylon retaining nut can be used to holds the devices in place on panels of less than 1-1/2" thick. See Drilling template for mounting dimensions.
The mounting plate fits over the front of the devices to hold them against panel or dashboard. Held in place by four black screws included.