Prevents dead batteries- Panel mount. #ba7a/.sw/hrna
Continuous alarm and LED indication.
The flashing red LED and alarm will sound if your battery becomes discharged to the level at which it must be charged. Low capacity.
Avoid dead battery due prolonged use, due to power failure, charger failure. Lets you know when battery must be charged. #BA7/SW/Hrna
Works with all kinds of 12 volt batteries.
For all kinds of storage batteries- Lead Acid, Gel Cell, AGM.
Ideal for vehicles that are in storage or with any 12 volt battery being stored for a prolonged period.
Use this with your battery charger to alert you to a power failure. This will tell you the coulomb capacity or when your battery or battery bank must be charged.
This device is connected to your battery with the included fuse harness. If your battery gets discharged below 12.0 volts ( 50% discharge) the alarm will sound and a red LED will glow. This allows you to know when you must begin recharging your battery before the discharge becomes excessive and permanent loss of battery life occurs.
Ideal for Motorcycles, Cars in storage, Snowmobiles, ATV, Boat batteries, Generator starting batteries, RV battery banks, Sump pumps, well pumps, sewage discharge pumps and bilge pumps.
This listing is for one (1) battery monitor alarm with wire leads, rubber mounting washer and 24" wire fused harness. When the battery voltage drops below 12.0 volts the flashing tonal alarm and LED will be active. The alarm is a 80 db piezoelectric alarm at 3000 hz. Operate down to 8 volts and up to 15 volts. Do not exceed 16 volts.
Mounts in a hole 1-1/8" in panels up to 1-1/2" thick or in panels of unlimited thickness with the mounting plate.